Bend Lines worden gebruikt om een zetting te markeren op plaatwerk. Het is niet nodig om de Bend Lines over de volledige lengte te graveren. Dit kost extra tijd en energie en daar moeten we tegenwoordig zuinig mee om gaan. Daarom is in de Publish Tool een handige functie ingebouwd
Is it possible to trim both sides of the bend lines in and DXF from a flat pattern? Of course it is possible to program this. In a post process these lines are then adjusted in the DXF. I wonder if there is interest in this. Send us an email if you
Select and configure in the settings menu the layers for the DXF. In this case the contour lines will be white, feature lines (on front side) will be red and the unconsumed sketch lines will be yellow. The hole chamfer is a feature as well and will be exported as
If you see an error icon, click on the icon to get a message that shows a description of the error. Flat pattern is not flat Punches outside model Punches not on same side Bend Radius ≠ Thickness Plates are interfering Sheet Metal style error
It is now possible to choose your colors by the Autocad index. Switch layers on/off is now possible The layers you make equal to the ‘contour lines’ will be put in the same layer with different colors in the DXF.
Welcome to WordPress. This is your first post. Edit or delete it, then start writing!
